2018 Toyota Land Cruiser Oil Filter in Peoria, AZ

Yes—the oil filter is replaced with every oil change because a loaded filter triggers a bypass that sends unfiltered oil through the engine.

The filter’s job is to trap the debris oil carries away. Once it fills, the bypass valve opens so flow continues, but the oil is no longer filtered. Replacing the filter with the oil restores full debris‑holding capacity from mile one of the next interval. Follow the manufacturer’s schedule and your vehicle’s usage pattern when planning changes.

• Fresh filter restores debris capacity immediately.
• Prevents extended operation on bypassed, unfiltered oil.
• Supports stable oil pressure and flow after service.

The service includes removing the old filter, fitting a new engine‑matched filter, renewing sealing surfaces, refilling with the specified oil grade, and performing a leak and level check.

Your technician cleans the filter mount, replaces the gasket or O‑ring as required, and torques components properly. After refilling, the engine is run to temperature to verify pressure and check for leaks at the filter and drain plug. The maintenance reminder (if equipped) is reset, and findings are reviewed with you.

• Engine‑matched filter installed with fresh seal.
• Sealing surfaces cleaned; drain plug addressed.
• Hot run, leak check, and final oil level verification.

The filter can load with debris, the bypass opens, and the engine circulates unfiltered oil—quietly increasing wear over time.

Oil will continue to flow, but without effective filtration, fine particles circulate to bearings and cam surfaces. Pressure stability can also suffer as the element becomes restricted. Replacing the filter with the oil prevents extended bypass operation and restores the system’s debris‑holding capacity.

• Bypass flow means oil is not filtered.
• Increased abrasive wear accumulates over time.
• Can contribute to pressure fluctuations when hot.

Yes—the filter is matched to this 5.7‑liter, 8‑cylinder engine, and filters are not interchangeable across engines.

Correct fitment ensures proper sealing, flow rate, filtration media area, and bypass valve characteristics for this V8. Using a non‑matched filter risks leaks, poor filtration, or incorrect bypass behavior. Your service advisor will install a filter appropriate to this engine and the oil grade the manufacturer specifies.

• Engine‑matched design and bypass settings.
• Correct sealing diameter and gasket style.
• Proper media area for flow and filtration balance.

It can be done, but it is not recommended because the partially loaded filter may force bypass and circulate unfiltered oil.

Changing oil alone leaves an old filter with reduced debris capacity in place. As the element loads, the bypass valve can open, defeating filtration when you most need it under heat and load. Replacing both together resets capacity and helps maintain stable pressure and cleanliness between services.

• Oil and filter work as a system.
• Skipping the filter risks unfiltered circulation.
• Paired replacement restores capacity immediately.

Use our online tool to schedule service or schedule an appointment, or call the store for assistance.

Choose a time that fits your day, and we’ll install an engine‑matched filter, renew seals, and complete a hot leak check on your 2018 Toyota Land Cruiser. Check current offers before you book to see available promotions.

• Book online: schedule service.
• See offers: service specials.
• Call us: {{rooftop.phone}}.